Small Combo Fold & Roll Instructions

	STEP 1: Unit is laying flat with all the air pushed out of it.  The most important thing to remember as you start your fold it is to keep the top material folded together without touching the bottom of the inflatable.  This is important to keep from transferring dirt, grass, etc from the bottom of the unit onto area that is seen while inflated.		STEP 2: Fold the slide over onto the top of the bounce house, folding it all the way until it is even with the bounce house on the outside.
	STEP 3: Fold again from the same side that the slide attaches to the bounce house.  This fold should go to the middle of the bounce house (middle of the input ramp).		STEP 4: Fold opposite side of bounce house over about 2 feet.
	STEP 5: Fold the same side over again to meet the opposite fold in the middle, you can overlap the material up to 1 foot (making sure that top material is on top material, and bottom material is on bottom material).		STEP 6: Fold the input ramp over, making sure that it is aligned with the rest of the folds.
	STEP 7: This is how it should look when you are ready to start rolling up the unit.  Make sure that the unit is uniform from end to end and about 5.5' wide, then start your roll at the seam of the input ramp.  The start of your roll should be as tight as possible, as this will influence how tight the unit is rolled when completed (make sure to clean all debri from bottom of unit as you roll).